The Challenges to Swim Spa Covers

Swim Spas represent special obstacles when it concerns covering them.
We can all agree that the swim spa needs to be covered when not in use for all the same factors a hot tub requires a cover. The challenge is that because of the length of the swim spa and the height of the sides, removing and replacing the cover can be a lot more difficult.
Getting a new swim spa is an amazing occasion in life. You’re looking forward to the workout you’ll get from using it. Maybe you’re a little relieved to have actually lastly made a selection from the different models you took a look at. At any rate, you most likely weren’t thinking much about the cover you would use.
Usually, the cover that gets back with your brand-new purchase will be a 4 section rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Up until it starts to get heavy.
Which it constantly does.
Every stiff foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a design defect. Integrated in obsolescence due to the fact that as soon as it is placed in use over the warm water in your swim spa it is unavoidable.
It’s not from rain, so having a taper will not make any distinction. In fact you might have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The particles of steam are really small as they increase from the water surface. They make their method into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being caught in the cover.
It occurs slowly and on a Swim Spa Cover which is made from private sections, at varying speeds. So ultimately you’ll observe one or two of the areas are truly getting heavy. The bar lifters on completions of the swim spa aren’t much help because you still have to raise that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com developed a various style for their Swim Spa Covers
Instead of using a number of foam panels to construct Swim Spa Covers that will eventually end up in some land fill, they created one that uses air chambers that don’t suck up wetness.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate better, will not blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine fabric, these covers will not fade, or break down at the joints either. So if you own a swim spa, and you mean to keep using it daily, SpaCap.com has the cover for it.
If you’re not all set to order today, bookmark this site so you can discover it once again when you’re ready!

Leave a Reply

Your email address will not be published. Required fields are marked *